THÔNG SỐ KỸ THUẬT:

Software:

-  Cisco Unified Wireless Network Software Release 8.10.x or later

-  Cisco IOS ® XE Software Release 16.12.1 with AP Device Pack, or later

Supported wireless LAN controllers:

-  Cisco Catalyst 9800 Series Wireless Controllers

-  Cisco 3504, 5520, and 8540 Wireless Controllers and Cisco Virtual Wireless Controller

802.11ac:

-  8×8 downlink MU-MIMO with eight spatial streams

-  PHY data rates up to 3.4 Gbps (8×8 80 MHz or Dual 4×4 80+80 MHz on 5GHz)

-  Wi-Fi Protected Access (WPA) 3 support

802.11ax:

-  8×8 uplink/downlink MU-MIMO with eight spatial streams

-  Uplink/downlink OFDMA

-  PHY data rates up to 5.38 Gbps (8×8 80 MHz or Dual 4×4 80+80 MHz on 5GHz and 4×4 20 MHz on 2.4)

-  WPA3 support

Integrated antenna:

-  2.4 GHz: Peak gain 4 dBi, internal antenna, omnidirectional in azimuth

-  5 GHz: Peak gain 6 dBi, internal antenna, omnidirectional in azimuth

External antenna with Smart antenna connector:

-  The Cisco Catalyst 9130AXE Access Point is certified for use with antenna gains up to 13 dBi (2.4 GHz and 5 GHz)

-  Cisco offers the industry’s broadest selection of antennas, delivering optimal coverage for a variety of deployment scenarios

-  Supports Self-Identifiable Antennas (SIA) on the smart antenna connector

-  Smart antenna connector is a compact multi-RF connector with 8-DART interface

-  Requires the AIR-CAB002-D8-R= 2 ft smart antenna connector when used with antennas with a RP-TNC connector

-  Requires the AIR-CAB003-D8-N= 3 ft smart antenna connector when used with AIR-ANT2513P4M-N= antenna

Interfaces:

-  1x 100, 1000, 2500, 5000 Multigigabit Ethernet (RJ-45) – IEEE 802.3az

-  Management console port (RJ-45)

-  USB 2.0 at 4.5W (enabled via future software)

Indicators:

-  Status LED indicates boot loader status, association status, operating status, boot loader warnings, and boot loader errors

Dimensions (W x L x H):

-  Access point (without mounting brackets): 8.9 x 8.9 x 1.88 in. (22.6 x 22.6 x 4.8 cm)

Weight:

-  3.2 lb. (1.45 kg)

Input power requirements:

-  802.3at Power over Ethernet Plus (PoE+), 802.3bt Cisco Universal PoE (Cisco UPOE ®)

-  Cisco power injector, AIR-PWRINJ6=

-  802.3af PoE

-  Cisco power injector, AIR-PWRINJ5= (Note: This injector supports only 802.3af)

System memory:

-  2048 MB DRAM

-  1024 MB flash